Cisco Nexus 1000V - Page 66

5-10
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 5 Upgrades
Problems with the GUI Upgrade
Example:
switch#(config)# show boot
sup-1
kickstart variable = bootflash:/nexus-1000v-kickstart-mz.4.0.4.SV1.3a.bin
system variable = bootflash:/nexus-1000v-mz.4.0.4.SV1.3a.bin
sup-2
kickstart variable = bootflash:/nexus-1000v-kickstart-mz.4.0.4.SV1.3a.bin
system variable = bootflash:/nexus-1000v-mz.4.0.4.SV1.3a.bin
No module boot variable set
switch#(config)#
Step 6 You have completed this procedure. Return to one of these sections:
• “Recovering a Secondary VSM with Active Primary” section on page 5-7
• “Recovering a Primary VSM with Active Secondary” section on page 5-12
Powering On the VSM
You can power on the newly created VSM.
Step 1 From the vCenter Server left-hand panel, right-click the VSM and then choose Power > Power On.
The VSM starts.
Step 2 You have completed this procedure. Return to the “Recovering a Primary VSM with Active Secondary”
section on page 5-12.