Cisco Nexus 1000V - Page 86

6-10
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 6 High Availability
High Availability Troubleshooting Commands
Example 6-7 show system internal active-active remote accounting logs Command
switch# show system internal active-active remote accounting logs
To reload a module, use the following command:
Example 6-8 reload module Command
switch# reload module 2
This command reloads the secondary VSM.
Note Entering the reload command without specifying a module will reload the whole system.
To attach to the standby VSM console, use the following command.
Example 6-9 attach module Command
The standby VSM console is not accessible externally, but can be accessed from the active VSM
through the attach module module-number command.
switch# attach module 2
This command attaches to the console of the secondary VSM.