Cisco Nexus 3000 series - Displaying Ospfv2 Statistics; Configuration Examples for Ospfv2

Send document comments to nexus3k-docfeedback@cisco.com
3-42
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Chapter 3 Configuring OSPFv2
Displaying OSPFv2 Statistics
Displaying OSPFv2 Statistics
To display OSPFv2 statistics, use the following commands:
Configuration Examples for OSPFv2
This example shows how to configure OSPFv2:
feature ospf
router ospf 201
router-id 290.0.2.1
show ip ospf neighbors [neighbor-id]
[detail]
[interface-type number] [vrf
{vrf-name | all | default | management}]
[summary]
Displays the list of OSPFv2 neighbors.
show ip ospf request-list
neighbor-id
[interface-type number]
Displays the list of OSPFv2 link-state requests.
show ip ospf retransmission-list
neighbor-id
[interface-type number]
Displays the list of OSPFv2 link-state retransmissions.
show ip ospf route [ospf-route]
[summary] [
vrf {vrf-name | all | default |
management}]
Displays the internal OSPFv2 routes.
show ip ospf summary-address [vrf
{vrf-name | all | default | management}]
Displays information about the OSPFv2 summary
addresses.
show ip ospf virtual-links [brief]
[vrf
{vrf-name | all | default | management}]
Displays information about OSPFv2 virtual links.
show ip ospf vrf
{vrf-name | all | default |
management}
Displays information about VRF-based OSPFv2
configuration.
show running-configuration ospf Displays the current running OSPFv2 configuration.
Command Purpose
Command Purpose
show ip ospf policy statistics area area-id
filter-list {in | out} [vrf {vrf-name | all |
default | management}]
Displays the OSPFv2 route policy statistics for an area.
show ip ospf policy statistics redistribute
{bgp id| direct | eigrp id | ospf id | rip id |
static} vrf
{vrf-name | all | default |
management}]
Displays the OSPFv2 route policy statistics.
show ip ospf statistics [vrf
{vrf-name | all
| default | management}]
Displays the OSPFv2 event counters.
show ip ospf traffic
[interface-type
number]
[vrf {vrf-name | all | default |
management}]
Displays the OSPFv2 packet counters.