Cisco Nexus 3000 series - Configuring Route Maps

Send document comments to nexus3k-docfeedback@cisco.com
11-12
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Chapter11 Configuring Route Policy Manager
Configuring Route Policy Manager
This example shows how to create a generic specific extended community list:
switch# configure terminal
switch(config)# ip extcommunity-list standard test1 permit 4bytegeneric transitive
65536:40 65536:60
switch(config)# copy running-config startup-config
Configuring Route Maps
You can use route maps for route redistribution or route filtering. Route maps can contain multiple match
criteria and multiple set criteria.
Configuring a route map for BGP triggers an automatic soft clear or refresh of BGP neighbor sessions.
SUMMARY STEPS
1. configure terminal
2. route-map map-name [permit | deny] [seq]
3. (Optional) continue seq
4. (Optional) exit
5. (Optional) copy running-config startup-config
DETAILED STEPS
Step 3
show ip community-list name
Example:
switch(config)# show ip community-list
BGPCommunity
(Optional) Displays information about extended
community lists.
Step 4
copy running-config startup-config
Example:
switch# copy running-config
startup-config
(Optional) Saves this configuration change.
Command Purpose
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
route-map map-name [permit | deny] [ seq ]
Example:
switch(config)# route-map Testmap permit
10
switch(config-route-map)#
Creates a route map or enters route-map configuration
mode for an existing route map. Use seq to order the
entries in a route map.
Step 3
continue seq
Example:
switch(config-route-map)# continue 10
(Optional) Determines what sequence statement to
process next in the route map. Used only for filtering
and redistribution.