Send document comments to nexus3k-docfeedback@cisco.com
5-23
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release5.0(3)U1(1)
Chapter 5 Configuring Basic BGP
Displaying BGP Statistics
Displaying BGP Statistics
To display BGP statistics, use the following commands:
Configuration Examples for Basic BGP
This example shows a basic BGP configuration:
feature bgp
router bgp 64496
neighbor 2001:ODB8:0:1::55 remote-as 64496
address-family ipv4 unicast
next-hop-self
Related Topics
The following topics relate to BGP:
• Chapter 11, “Configuring Route Policy Manager.”
Where to Go Next
See Chapter 6, “Configuring Advanced BGP” for details on the following features:
• Peer templates
• Route redistribution
• Route maps
Additional References
For additional information related to implementing BGP, see the following sections:
• Related Documents, page 5-24
• MIBs, page 5-24
Command Purpose
show bgp ip {unicast | multicast}
[ip-address] flap-statistics [vrf vrf-name]
Displays the BGP route flap statistics. Use the clear bgp
flap-statistics command to clear these statistics.
show bgp sessions [vrf vrf-name] Displays the BGP sessions for all peers. Use the clear
bgp sessions command to clear these statistics.
show bgp sessions [vrf vrf-name] Displays the BGP sessions for all peers. Use the clear
bgp sessions command to clear these statistics.
show bgp statistics Displays the BGP statistics.
To Next Page
Loading...
