Cisco Nexus 3000 series - Verifying the Object Tracking Configuration; Configuration Examples for Object Tracking; Related Topics; Additional References

Send document comments to nexus3k-docfeedback@cisco.com
14-13
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release5.0(3)U1(1)
Chapter 14 Configuring Object Tracking
Verifying the Object Tracking Configuration
switch(config-track)# vrf member Blue
switch(config-track)# copy running-config startup-config
Verifying the Object Tracking Configuration
To display the object tracking configuration information, perform one of the following tasks:
Configuration Examples for Object Tracking
This example shows how to configure object tracking for route reachability and use VRF Red to look up
reachability information for this route:
switch# configure terminal
switch(config)# track 2 ip route 209.165.201.0/8 reachability
switch(config-track)# vrf member Red
switch(config-track)# copy running-config startup-config
Related Topics
See the following topics for information related to object tracking:
• Chapter 9, “Configuring Layer 3 Virtualization”
• Chapter 12, “Configuring HSRP”
Additional References
For additional information related to implementing object tracking, see the following sections:
• Related Documents, page 14-14
• Standards, page 14-14
Command Purpose
show track [object-id] [brief] Displays the object tracking information for one
or more objects.
show track [object-id] interface [brief] Displays the interface-based object tracking
information.
show track [object-id] ip route [brief] Displays the IPv4 route-based object tracking
information.