Send document comments to nexus3k-docfeedback@cisco.com
2-14
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Chapter2 Configuring IPv4
Verifying the IPv4 Configuration
To enable IP directed broadcasts, use the following command in interface configuration mode:
Verifying the IPv4 Configuration
To display the IPv4 configuration, perform one of the following tasks:
Configuration Examples for IPv4
This example shows how to configure an IPv4 address:
configure terminal
interface ethernet 1/2
no switchport
ip address 192.2.1.1/16
Additional References
For additional information related to implementing IP, see the following sections:
• Related Documents, page 2-15
• Standards, page 2-15
Command Purpose
ip directed-broadcast Enables the translation of a directed broadcast to physical
broadcasts
Command Purpose
show hardware forwarding ip verify Displays the IP packet verification configuration.
show ip adjacency Displays the adjacency table.
show ip arp Displays the ARP table.
show ip interface Displays IP related interface information.
show ip arp statistics [vrf vrf-name] Displays the ARP statistics.
To Next Page
Loading...
