Cisco Nexus 3000 series - Page 330

Send document comments to nexus3k-docfeedback@cisco.com
Index
IN-2
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release5.0(3)U1(1)
MP-BGP 6-9
next-hop address tracking 6-7
path selection 5-4
prerequisites 5-7, 6-9
router ID 5-4
speakers 5-1
tuning 6-33
unicast RIB 5-7
verifying configuration 5-21, 6-38
virtualization support 5-7, 6-9
BGP aggregate addresses
configuring
6-28
BGP AS-path lists
configuring
11-8
description 11-4
BGP authentication
configuring
6-19
description 6-2
BGP autonomous systems
description
5-2
BGP capabilities negotiation
description
6-5
disabling 6-21
BGP community lists
configuring
11-9, 11-11
description 11-4
BGP extended community lists
description
11-4
BGP instance
creating
5-12
deleting 5-13
restarting 5-13
BGP load balancing
configuring
6-26
BGP loadsharing
description
6-6
BGP multipath. See BGP loadsharing
BGP peers
authentication (note)
6-2
configuring 5-14, 5-16
description 5-3
BGP route aggregation
description
6-7
BGP route dampening 6-6
BGP route redistribution
configuring
6-30
description 6-8
BGP sessions
reset options
6-3
resetting 6-20
route policies 6-3
BGP templates
configuring peer-policy templates
6-13
configuring peer templates 6-16
configuring session templates 6-11
description 6-2
peer-policy templates 6-2
peer-session templates 6-2
peer template 6-2
Border Gateway Protocol. See BGP
C
communication cost 1-4
community lists
configuring
11-9, 11-11
description 11-4
comparing
link-state and distance vector routing algorithms
1-9
D
default gateway
description
1-8
default settings
BGP
5-10, 6-10
EIGRP 4-8