EasyManua.ls Logo

Cisco Nexus 9408 - Managing the Switch; Displaying Information about the Installed Hardware Modules

Cisco Nexus 9408
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 6
Managing the Switch
Displaying Information About the Installed Hardware Modules, on page 41
Displaying the Hardware Inventory for the Switch, on page 44
Displaying the Modules for the Switch, on page 45
Displaying the Serial PROM (SPROM) for the Switch, on page 46
Displaying Environmental Information for the Switch, on page 47
Displaying Environment Temperature for the Switch, on page 48
Displaying Information About the Installed Hardware Modules
You can display information about the switch hardware and the hardware modules that are installed in the
switch by using the show hardware command.
ASW4_QP_LEM# show hardwareCisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (C) 2002-2022, Cisco and/or its affiliates.
All rights reserved.
The copyrights to certain works contained in this software are
owned by other third parties and used and distributed under their own
licenses, such as open source. This software is provided "as is," and unless
otherwise stated, there is no warranty, express or implied, including but not
limited to warranties of merchantability and fitness for a particular purpose.
Certain components of this software are licensed under
the GNU General Public License (GPL) version 2.0 or
GNU General Public License (GPL) version 3.0 or the GNU
Lesser General Public License (LGPL) Version 2.1 or
Lesser General Public License (LGPL) Version 2.0.
A copy of each such license is available at
http://www.opensource.org/licenses/gpl-2.0.php and
http://opensource.org/licenses/gpl-3.0.html and
http://www.opensource.org/licenses/lgpl-2.1.php and
http://www.gnu.org/licenses/old-licenses/library.txt.
Software
BIOS: version 01.09
NXOS: version 10.3(2) [Feature Release]
Host NXOS: version 10.3(2)
BIOS compile time: 09/28/2022
NXOS image file is: bootflash:///nxos64-cs.10.3.2.F.bin_24
NXOS compile time: 11/30/2022 12:00:00 [12/16/2022 04:02:06]
NXOS boot mode: LXC
Hardware
Cisco Nexus 9408 NX-OS Mode Switch Hardware Installation Guide
41

Table of Contents

Other manuals for Cisco Nexus 9408

Related product manuals