Cisco Nexus 9408 - Fan Leds

DescriptionStatusLEDComponent
All diagnostics pass. This module is operational.Solid on (green)STSLEM
1. This module has detected a slot ID parity error and will
not power on or boot up.
2. The module is not fully inserted.
3. The diagnostic test has failed.
Solid on (amber)
1. This module has just been powered on, and the module is
resetting.
2. The module is resetting and both ejector levers are out.
3. The module has been inserted during the initialization
process (transition state).
4. The module could not power up because of insufficient
power.
5. An over-temperature condition has occurred. A major
temperature threshold has been exceeded.
Blinking (amber)
This module is not receiving power.Off
The operator has activated this LED to identify this module in
the chassis.
Blinking (blue)BCN
This module is not being identifiedOff
The port is active and the link is up.
Solid on (green)Port
The port is disabled by the operator or is not initializing.Solid on (yellow)
The port is faulty and disabled.Blinking (yellow)
The port is not active or the link is not connected.Off
Fan LEDs
This table provides information about fan LEDs for Cisco Nexus 9400 Series switches.
Cisco Nexus 9408 NX-OS Mode Switch Hardware Installation Guide
59
LEDs
Fan LEDs