Cisco Power system - Chapter 1 Overview; Features

CHAPTER
1-1
Cisco Redundant Power System Hardware Installation Guide
OL-3654-01
1
Overview
The Cisco 600W Redundant Power System (RPS) provides power system
redundancy to external devices such as routers, switches, and hubs. The system
includes two fully redundant AC input power modules and four DC output power
modules for connection to external devices. The Cisco RPS supports
quasi-redundant, fully redundant, or redundant-with-reboot configurations,
depending upon the external device.
This chapter provides an overview of the Cisco RPS features, including the
supported external devices and power configurations, in the following sections:
• Features, page 1-1
• Supported Devices and Configurations, page 1-2
• Front and Rear Panel Descriptions, page 1-8
• Safety Recommendations, page 1-11
Features
The following features are standard:
• Two AC input power cords
• Two fully redundant AC input power modules
• Four 150W DC output power modules
• Rack-mountable chassis (19-inch rack-mount brackets included)
• Redundant cooling fans