Cisco Power system - Mounting the Chassis in a Rack

Chapter 2 Installing the Cisco RPS
Rack-Mounting the Cisco RPS
2-8
Cisco Redundant Power System Hardware Installation Guide
OL-3654-01
Figure 2-5 Telco Bracket Installation—Rear Panel Forward
Mounting the Chassis in a Rack
After the brackets are secured to the chassis, use your own screws to attach the
chassis to the rack, as shown in Figure 2-6.
Figure 2-6 Attaching the Chassis to a Rack—Rear Panel Forward
D
C
O
U
T
P
U
T
3
D
C
O
U
T
P
U
T
4
11540
Note: The second bracket attaches to the other side of the chassis.
The brackets can also be installed with the Cisco RPS front panel forward.
H9699
Note: The second bracket attaches to the rack at the other side of the chassis.
D
C
O
U
T
P
U
T
3
D
C
O
U
T
P
U
T
4