Chapter 5 Troubleshooting the Cisco RPS
Error Messages on Cisco 2600 Series and Cisco 3620, Cisco 3640, and Cisco 3725 Routers
5-12
Cisco Redundant Power System Hardware Installation Guide
OL-3654-01
Multiple Errors
LED status:
Two or more of the Cisco RPS LEDs are amber.
Console Error Message:
• When an external device console screen displays the Cisco IOS software
prompt (
routername> or routername#)
There is more than one failure with the redundant power systems;
please resolve problems immediately.
The Cisco IOS software checks the condition once every 30 seconds. If the
condition still exists, the error message reappears.
Note It is not a multiple failure when two or more DC output modules have failed.
• When an external device console screen displays the ROMMON prompt
(
rommon#>),
The message will vary depending on the mix of failures.
Error Description:
The Cisco RPS has two or more failures of any of the previous types.
SNMP Trap Issued Upon Error:
ciscoEnvMonRedundantSupplyNotification is generated.
The varbinds included are ciscoEnvMonSupplyStatusDescr and
ciscoEnvMonSupplyState.
The value of ciscoEnvMonSupplyState is a warning.
How to Correct Error:
Look at the LEDs on the Cisco RPS front panel to determine the types of failures
that have occurred. Go to the section in Table 5-1 describing each failure type for
instructions on how to correct it.
If the error message persists, replace the Cisco RPS.
To Next Page
Loading...
General