Cisco RV 120W Administration Guide

Introduction
Connecting the Equipment
Cisco RV 120W Administration Guide 14
1
• PPTP (Europe)—Provide your account name (for example,
john@ISPname.net ), password, and server IP address. Click Next after
entering the information.
• L2TP (Europe)—Provide your account name (for example,
john@ISPname.net), password, and server IP address. Click Next after
entering the information.
STEP 5 The Setup Wizard configures your connection, verifies the router settings, and
checks the network connection. Click Next.
STEP 6 To configure your home network, click Next.
Configuring Security
STEP 1 Enter a new Cisco RV 120W administration password and click Next. For security
reasons, you should not use the default password. Follow these password
guidelines:
• Passwords should not contain dictionary words from any language or the
default password.
• Passwords should contain a mix of letters (both upper- and lowercase),
numbers, and symbols.
• Passwords must be at least 8 but no more than 30 characters.
• Password security ratings are shown to the right of the password you enter,
and are rated from weak to secure. Cisco recommends using a password
rated as secure.
STEP 2 Enter a name (SSID) for your wireless network and click Next. You should change
the default SSID to a unique name. The SSID is case-sensitive.
NOTE For added security, disable broadcasting of the SSID. You can disable SSID
broadcast using the Device Manager; see Editing an AP’s Properties, page 67.

Cisco RV 120W Specifications

General

Brand	Cisco
Model	RV 120W
Category	Network Router
Language	English