EasyManuals Logo

Cisco SCE8000 Installation And Configuration Guide

Cisco SCE8000
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
8-3
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
Chapter 8 Troubleshooting
Troubleshooting Overview
Troubleshooting the management subsystem:
show interface GigabitEthernet 1/1 — Displays IP address and auto-negotiation information
for the management interfaces.
Following is a sample output from the show interface GigabitEthernet 1/1 command.
ip address: 10.1.6.145
subnet mask: 255.255.0.0
Configured speed: auto, configured duplex: auto
AutoNegotiation is On, link is Up, actual speed: 100, actual duplex: half
show ip default-gateway — Displays the IP address of the configured default gateway.
Following is a sample output from the show ip default-gateway command.
Default gateway: 10.1.1.1
show ip route — Displays the entire routing table and the destination of last resort
(default-gateway).
Following is a sample output from the show ip route command.
gateway of last resort is 10.1.1.1
show access-lists — Shows all access-lists or a specific access list.
Following is a sample output from the show access-lists command.
Standard IP access list 1
Permit 10.1.1.0, wildcard bits 0.0.0.255
deny any
show telnet — Displays the status of the telnet server daemon ( status ) or any active Telnet
sessions ( sessions ).
Following is a sample output from the show telnet command.
show telnet sessions
There is 1 active telnet session:
Index | Source
================
0 | 10.1.1.201
show telnet status
Telnet deamon is enabled.
show line vty timeout — Shows the timeout configured for Telnet sessions.
Following is a sample output from the show line vty timeout command.
Timeout is 30 minutes
Troubleshooting the link interface subsystem:
show interface TenGigabitEthernet 3/#/0 — Displays information for a specific 10GBE
Interface.
Following is a sample output from the show interface command.
Auto negotiation configured: Disabled
Actual status:
Link is: ON
Auto negotiation: Disabled
Bandwidth (L1): 10000000 Kbps, Burst-size: 500000 bytes
Pseudo IP Address: Not Configured

Table of Contents

Other manuals for Cisco SCE8000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SCE8000 and is the answer not in the manual?

Cisco SCE8000 Specifications

General IconGeneral
BrandCisco
ModelSCE8000
CategoryNetwork Hardware
LanguageEnglish

Related product manuals