ix
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
About this Guide
This preface describes who should read the Cisco SCE8000 Installation and Configuration Guide, how
it is organized, and its document conventions.
This guide is for the networking or computer technician responsible for installing and configuring the
SCE8000 platform on-site. To use this publication, you should be familiar with telecommunications
equipment and installation procedures, as well as electronic circuitry and wiring practices. You should
also have experience as an electronic or electromechanical technician.
This installation guide explains the initial hardware installation and basic configuration procedures for
the SCE8000. It contains procedures for unpacking and installing the device and performing basic
configuration via the setup wizard. After completing the installation and basic configuration procedures
covered in this guide, you will then use the appropriate companion publications to more completely
configure your system.
This guide contains instructions on how to install and run the SCE8000 platform. This guide assumes a
basic familiarity with telecommunications equipment and installation procedures.
Document Revision History
Revision
Cisco Service Control
Release and Date Change Summary
OL-16478-03 3.1.7
November 23, 2010
Added information regarding power consumption in Chapter 4, “Installing the
Cisco SCE8000 Chassis”.
Updated AC Power Specifications in Chapter 4, “Installing the Cisco
SCE8000 Chassis”.
OL-16478-02 3.1.7
December, 2008
Added explanation of casacade topology and cabling.
OL-16478-01 3.1.6S
June, 2008
First version. New document for new product.
To Next Page
Loading...
Need help?
General
