7-5
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
Chapter 7 Basic Cisco SCE8000 Platform Operations
Managing Cisco SCE8000 Configurations
Managing Cisco SCE8000 Configurations
After you have installed your SCE8000 platform hardware, checked all external connections, turned on
the system power, and allowed the system to boot up, you are ready to install the Service Control
application. However, before you install the application, you might need to configure the SCE platform.
Instructions for configuring the SCE8000 platform are beyond the scope of this publication.
For further information on system and interface configuration, refer to the following documents:
• Cisco SCE8000 Software Configuration Guide
• Cisco SCE8000 CLI Command Reference
The procedures for managing Cisco SCE8000 configurations are explained in the following sections:
• Viewing Configurations, page 7-5
• Saving or Changing the Configuration Settings, page 7-6
• Restoring a Previous Configuration, page 7-8
Viewing Configurations
When you enter configuration commands, it immediately affects the SCE platform operation and
configuration. This configuration, referred to as the running-config, is saved in the SCE platform volatile
memory and is effective while the SCE platform is up. After reboot, the SCE platform loads the
startup-config, which includes the non-default configuration that was saved by the user, into the
running-config.
The SCE platform provides commands for:
• Viewing the running configuration with only user-configured (non-default) values: show
running-config
• Viewing the running configuration with all the SCE platform running configuration values, whether
default or not: show running-config all-data
• Viewing the startup configuration: show startup-config
After configuring the SCE platform, you may query for the running configuration using the command
show running-config.
Step 1 At the Cisco SCE8000# prompt, type show running-config.
The system shows the running configuration.
SCE8000#>show running-config
#This is a general configuration file (running-config).
#Created on 12:06:13 UTC SUN May 11 2008
#cli-type 1
#version 1
no management-agent notifications notification-list
1417,1418,804,815,1404,1405,1406,1407,1408,400
no management-agent notifications notification-list
402,421,440,441,444,445,446,450,437,457
no management-agent notifications notification-list 3593,3594,3595,10040
snmp-server community "public" ro
RDR-formatter forwarding-mode multicast
RDR-formatter destination 10.56.96.26 port 33000 category number 1 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 2 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 3 priority 100
To Next Page
Loading...
Need help?
General
