2-15
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
Chapter 2 Introduction to the Cisco SCE8000 Platform
Cisco SCE8000 Installation Checklist
AC/DC power cables connected to AC/DC sources and Cisco
SCE8000 chassis
Optical bypass modules installed (optional)
Console port set for 9600 baud, 8 data bits, no parity, and 1 stop bit
(9600 8N1)
ASCII terminal attached to console port
Management port is operational
Network interface cables and devices connected
System power turned on
System boot complete (Status LED is on)
10 GBE line ports operational
Correct hardware configuration displayed after system banner
appears
Table 2-11 Cisco SCE8000 Installation Checklist (continued)
Task Verified By Date
To Next Page
Loading...
