Cisco SF 302-08P User Manual

VLAN Management
VLAN GROUPS
Cisco Small Business 300 Series Managed Switch Administration Guide 119
11
STEP 4 Select an interface type (Port or LAG), and click Go. The following fields are
displayed in the GVRP Setting Table.
• Interface—Port or LAG number.
• GVRP State—Displays whether GVRP is enabled/disabled on the interface.
• Dynamic VLAN Creation—Displays whether Dynamic VLAN creation is
enabled/disabled on the interface. If it is disabled, GVRP can operate but
new VLANs are not created.
• GVRP Registration—Displays whether VLAN registration through GVRP is
enabled/disabled on the port.
STEP 5 To define GVRP settings for a port, select it, and click Edit. The Edit GVRP Setting
Page
opens.
STEP 6 Enter the values for the following fields:
• Interface—Select the interface (Port or LAG) to be edited.
• GVRP State—Select to enable GVRP on this interface.
• Dynamic VLAN Creation—Select to enable Dynamic VLAN Creation on this
interface.
• GVRP Registration—Select to enable VLAN Registration using GVRP on
this interface.
STEP 7 Click Apply. GVRP settings are modified, and the switch is updated.
VLAN GROUPS
Assigning MAC-based VLAN Groups
Use this feature to assign untagged traffic from specific MAC addresses to a
specific VLAN for devices in Layer 2 mode. This assignment is performed in
stages:
1. Assign the MAC address to a Group ID (an identifier created by using the
MAC
Based Groups Page
).
2. For each interface, assign the VLAN group to a VLAN by using
Mapping Group
to VLAN Page
. (The interfaces must be in General mode.)

Cisco SF 302-08P Specifications

General

Brand	Cisco
Model	SF 302-08P
Category	Switch
Language	English