Configuring SNMP
Notification Recipients
Cisco Small Business 300 Series Managed Switch Administration Guide 292
19
• Notification Filter—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the Notification
Filter Page.
• Filter Name—Select the SNMP filter that defines the information contained
in traps (defined in the Notification Filter Page).
• (Inform) Timeout—Enter the number of seconds the device waits before re-
sending informs. Timeout range: 1-300, default: 15.
• (Inform) Retries—Enter the number of times that the device resends an
inform request. Retires range:1-255, default: 3
STEP 4 Click Apply. The SNMP Notification Recipient settings are defined, and the switch
is updated.
Defining SNMPv3 Notification Recipients
To define a recipient in SNMPv3:
STEP 1 Click SNMP > Notification Recipient SNMPv3. The
SNMPv3 Notification
Recipient Page
opens.
This page displays recipients for SNMPv3.
STEP 2 Click Add. The
Add SNMP Notification Recipient Page
opens.
STEP 3 Enter the parameters.
• IP Version—Select either IPv4 or IPv6.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—Select the link local interface (if IPv6 Address Type
Link Local is selected) from the list.
To Next Page
Loading...
Need help?
General
