Cisco SG350-28 User Manual

1
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 8
Getting Started
This section provides an introduction to the web-based configuration utility, and covers the
following topics:
• Starting the Web-based Configuration Utility
• Out-Of-Band Port
• USB Port
• Basic or Advanced Display Mode
• Quick Start Device Configuration
• Interface Naming Conventions
• Window Navigation
• Search Facility
Starting the Web-based Configuration Utility
This section describes how to navigate the web-based switch configuration utility.
If you are using a pop-up blocker, make sure it is disabled.
Browser Restrictions
If you are using IPv6 interfaces on your management station, use the IPv6 global address and
not the IPv6 link local address to access the device from your browser.

Cisco SG350-28 Specifications

General

Model	SG350-28
Category	Switch
Switching Capacity	56 Gbps
Layer	Layer 3
Power Supply	Internal
Form Factor	Rack-mountable
Relative Humidity	10% to 90% non-condensing
MAC Address Table Size	16K entries
Power Dedicated to PoE	Not applicable
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Power Consumption	24W
Input Voltage	100-240V AC, 50/60Hz
Jumbo Frame Support	Supported
Weight	3.2 kg