Cisco SG350-28 User Manual

7
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 116
Administration: Stack Management
This section describes how stacks are managed. It covers the following topics:
NOTE Stacking is only supported on the SG350 (except for the Sx350) and SG550 family of devices.
•Overview
• Types of Units in Stack
• Stack Topology
• Unit ID Assignment
• Master Selection Process
• Stack Changes
• Unit Failure in Stack
• Software Auto Synchronization in Stack
• Stack Management
• Stack Management
Overview
Devices can either function on their own, or they can be connected into a stack of devices in
various stacking modes (see Stack Unit Mode).
By default, a device is always stackable, but has no port configured as a stack port. All the
ports in the devices are configured as network ports by default. A device without any stack
port can be thought of as the master device in a stack of only itself or as a standalone device.
To stack two or more devices, reconfigure the desired network ports as stack ports in the
devices and connect the devices with the resulting stack ports in a ring or chain topology.

Cisco SG350-28 Specifications

General

Model	SG350-28
Category	Switch
Switching Capacity	56 Gbps
Layer	Layer 3
Power Supply	Internal
Form Factor	Rack-mountable
Relative Humidity	10% to 90% non-condensing
MAC Address Table Size	16K entries
Power Dedicated to PoE	Not applicable
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Power Consumption	24W
Input Voltage	100-240V AC, 50/60Hz
Jumbo Frame Support	Supported
Weight	3.2 kg