Name: Cisco SG350-28
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

SNMP

Trap Settings

371 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

Read Write—Management access is read-write. Changes can be made to the device

configuration, but not to the community.

SNMP Admin—User has access to all device configuration options, as well as

permissions to modify the community. SNMP Admin is equivalent to Read Write

for all MIBs except for the SNMP MIBs. SNMP Admin is required for access to the

SNMP MIBs.

- View Name—Select an SNMP view (a collection of MIB subtrees to which access

is granted).

• (Community Type) Advanced—Select this type for a selected community.

- Group Name—Select an SNMP group that determines the access rights.

STEP 4 Click Apply. The SNMP Community is defined, and the Running Configuration is updated.

Trap Settings

The Trap Settings page enables configuring whether SNMP notifications are sent from the

device, and for which cases. The recipients of the SNMP notifications can be configured in the

SNMPv1.2 Notification Recipients page, or the SNMPv3 Notification Recipients page.

To define trap settings:

STEP 1 Click SNMP > Trap Settings.

STEP 2 Select Enable for SNMP Notifications to specify that the device can send SNMP

notifications.

STEP 3 Select Enable for Authentication Notifications to enable SNMP authentication failure

notification.

STEP 4 Click Apply. The SNMP Trap settings are written to the Running Configuration file.

Notification Recipients

Trap messages are generated to report system events, as defined in RFC 1215. The system can

generate traps defined in the MIB that it supports.

Questions and Answers:

Need help?

Do you have a question about the Cisco SG350-28 and is the answer not in the manual?

Cisco SG350-28 Specifications

General