Name: Cisco SG350-28
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

SNMP

Notification Recipients

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 374

• Filter Name—Select the SNMP filter that defines the information contained in traps

(defined in the Notification Filterpage).

STEP 5 Click Apply. The SNMP Notification Recipient settings are written to the Running

Configuration file.

SNMPv3 Notification Recipients

To define a recipient in SNMPv3:

STEP 1 Click SNMP > Notification Recipients SNMPv3.

This page displays recipients for SNMPv3.

• Informs IPv4 Source Interface—Select the source interface whose IPv4 address will

be used as the source IPv4 address in inform messages for communication with IPv4

SNMP servers.

• Traps IPv4 Source Interface—Select the source interface whose IPv6 address will be

used as the source IPv6 address in trap messages for communication with IPv6 SNMP

servers.

• Informs IPv6 Source Interface—Select the source interface whose IPv4 address will

be used as the source IPv4 address in inform messages for communication with IPv4

SNMP servers.

• Traps IPv6 Source Interface—Select the source interface whose IPv6 address will be

used as the source IPv6 address in trap messages for communication with IPv6 SNMP

servers.

STEP 2 Click Add.

STEP 3 Enter the parameters.

• Server Definition—Select whether to specify the remote log server by IP address or

name.

• IP Version—Select either IPv4 or IPv6.

• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are:

Questions and Answers:

Need help?

Do you have a question about the Cisco SG350-28 and is the answer not in the manual?

Cisco SG350-28 Specifications

General