Smart Network Application (SNA)
Services
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 705
29
For each of these services, the tickets showing the current configurations for the selected
interfaces display the following identifying information in addition to service specific
parameters:
• Interface name
• Device host name (of the parent device of the interface)
• IP address (of the parent device of the interface)—If more than one IP address exists
for the device, the IP address used by SNA to access the device is displayed.
• Device model (of the parent device of the interface)—The alphanumeric string
representing the device model. For example: SG350XG-2F10.
Power Management Settings
This service configures the Power settings on specific ports. This service can only be run when
all selected ports belong to the same device (or stack).
Displayed Parameters
• PoE Administrative Status (Enabled/Disabled)—This parameter only appears for PoE
ports.
• Port Power Priority (Low/High/Critical)—This parameter only appears for PoE ports.
• SNA Power Schedule (Applied/Not Applied)—This parameter appears only if the
device has a power schedule created by SNA.
• Schedule behavior—This information appears only if the port has an applied SNA-
defined power schedule. The possible values are:
- PoE power inactive
- Data inactive
- PoE power and data inactive
Editable Parameters
• PoE Administrative Status (Enabled/Disabled)—This control only appears if at least
one PoE ports is selected for the service, and is only applied to the PoE ports.
• Port Power Priority (Low/High/Critical)—This control only appears if at least one PoE
ports is selected for the service, and is only applied to the PoE ports.
• SNA Power Schedule (Applied/Not Applied—This control appears only if the device
has a power schedule created by SNA.
To Next Page
Loading...