Cisco SPA504 User Manual

For customers in AL, FL, GA, KS, SC, TN
MGCP.U.1304.O
18
Using Speed Dials
Cisco SPA504G, SPA509G:
To call one of your configured speed dial numbers, either:
• Open a phone line and press the number on the phone keypad for the speed dial, then press Dial. Or:
• Open a phone line and Dial the saved Speed Dial sequence number that you have added in CommPortal.
Monitoring/Accessing Another Phone from Your Phone
WOW! Business can configure your phone so that you can monitor other users’ phones with the use of the
Cisco SPA 500s Module. If this feature is required, you must add the SPA 500s Expansion Module. Line
buttons on the SPA 500s Expansion Module can be used to display the status of another user’s phone. For
example, if one of your SPA 500s buttons is configured to display Ray’s phone line, the LED color will show
you the status of his phone line:
• Green: Line is idle.
• Red (steady): Line is active or in use.
• Red (blinking): Line is ringing.
• Orange (solid): Line is unregistered (cannot be used).
• Orange (blinking): Line is not configured properly.
Customizing Your LCD Screen
You can customize your LCD screen in several ways.
Changing the LCD Screen Contrast
To adjust the contrast of the LCD screen:
1. Press the Setup button, scroll to highlight LCD Contrast, and press the select button.
2. Use the navigation button to adjust the screen contrast. Pressing the Left navigation button decreases
the contrast. Pressing the Right navigation button increases the contrast.
3. Press save.

Cisco SPA504 Specifications

General

Lines Supported	4
Network Protocols	SIP, SPCP
Display	128 x 64 monochrome LCD
Ethernet Ports	2 (10/100 Mbps)
Power over Ethernet	Yes
Audio Codecs	G.711, G.729a, G.722
Speakerphone	Yes
Headset Port	Yes, 2.5 mm