Cisco TrustSec - Page 100

7-14
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
default timer reauthentication (cts interface)
default timer reauthentication (cts interface)
Use the default timer reauthentication command in CTS interface configuration mode to reset the CTS
dot1x reauthentication timer to the default value.
default timer reauthentication
Syntax Description
Defaults 3600 seconds
Command Modes CTS interface configuration (config-if-cts-dot1x)
Supported User Roles Administrator
Command History
Usage Guidelines The default value of the CTS reauthentication timer is the global dot1x reauthentication default (3600
seconds). When this timer expires, the device reauthenticates to the CTS network (NDAC).
Examples The following example resets the CTS reauthentication timer to the global default values:
Router # configure terminal
Router(config)# interface gigabitEthernet 3/1
Router(config-if)# cts dot1x
Router(config-if-cts-dot1x)# default timer reauthentication
Related Commands
timer reauthentication Sets the CTS reauthentication timer to the default values.
Release Modification
12.2(33) SXI This command was introduced on the Catalyst 6500 series switches.
Command Description
cts dot1x Enters CTS dot1x interface configuration mode (config-if-cts-dot1x).
timer reauthentication
(cts interface)
Sets the CTS reauthentication timer.
show cts interface Displays CTS interface status and configurations.
show dotx interface Displays IEEE 802.1x configurations and statistics.