Cisco TrustSec - Page 101

7-15
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
timer reauthentication (cts interface)
timer reauthentication (cts interface)
Use the timer reauthentication command in CTS interface configuration mode to set the
reauthentication timer. Use the no form of the command to disable the timer.
[no] timer reauthentication seconds
Syntax Description
Defaults None
Command Modes CTS interface configuration (config-if-cts-dot1x)
Supported User Roles Administrator
Command History
Usage Guidelines This command sets the TrustSec reauthentication timer. When this timer expires, the device
reauthenticates to the CTS network (NDAC).
Examples The following example sets the reauthentication timer to 44 seconds:
Router(config-if-cts-dot1x)# timer reauthentication 44
Related Commands
reauthentication seconds Sets the reauthentication timer.
Release Modification
12.2(33) SXI This command was introduced on the Catalyst 6500 series switches.
Command Description
cts dot1x Enters CTS dot1x interface configuration mode (config-if-cts-dot1x).
default timer
reauthentication (cts
interface)
Resets the CTS dot1x reauthentication timer to the default value.
show cts interface Displays CTS interface status and configurations.
show dotx interface Displays IEEE 802.1x configurations and statistics.