Cisco TrustSec - Page 102

7-16
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
cts layer3
cts layer3
Use the cts layer 3 interface configuration command to enable CTS Layer3 Transport gateway
interfaces, and to apply exception and traffic policies to them.
cts layer3 {ipv4 | ipv6} {policy | trustsec forwarding}
Syntax Description
Defaults CTS Layer3 Transport is not enabled by default.
Command Modes Interface configuration (config-if)
Supported User Roles Administrator
Command History
Usage Guidelines Use the cts policy layer3 global configuration command to specify which traffic and exception
commands to apply to the CTS Layer3 gateway. Use the cts layer3 interface configuration command to
enable the CTS Layer3 gateway interface and to apply the traffic and exception policies. See cts policy
layer3 for further information on traffic and exception policies.
Examples The following example enables a CTS Layer3 Transport gateway interface:
Router# config t
Router(config)# interface gigabitEthernet 6/1
Router(config-if)# cts layer3 ipv4 trustsec forwarding
Router(config-if)# cts layer3 ipv4 trustsec
Router(config-if)# cts layer3 ipv4 policy
Related Commands
ipv4 | ipv6 Specify IPv4 or IPv6
policy Applies the traffic and exception policies on the gateway interface.
trustsec forwarding Enables CTS Layer3 Transport on the gateway interface.
Release Modification
12.2(50) SY This command was introduced on the Catalyst 6500 Series Switches.
Command Description
cts policy layer3 Specifies traffic and exception policies for CTS Layer 3 Transport.
show cts policy layer3 Displays the name of traffic and exception polices used for CTS Layer3
Transport configurations.