Cisco TrustSec - Page 136

7-50
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
clear cts policy
clear cts policy
To delete the peer authorization policy of a TrustSec peer, use the the clear cts policy command in
privileged EXEC mode.
clear cts policy {peer [peer_id] | sgt [sgt]}
Syntax Description
Defaults None
Command Modes Privileged EXEC (#)
Supported User Roles Administrator
Command History
Usage Guidelines
ExamplesTo clear
the peer
authorization
policy of all
TrustSec peers, use
the clear cts policy
peer command
without specifying
a peer ID. To clear
the Security Group
tag of the TrustSec
peer, use theclear
cts policy sgt
command. Use the
show cts policy
peer command to
verify.
The following example clears the peer authorization policy of the TrustSec peer with the peer ID atlas2:
Router# clear cts policy peer atlas2
Delete all peer policies? [confirm] y
Router#
peer peer_id Specifies the peer ID of the TrustSec peer device.
sgt sgt Specifies the Security Group Tag (SGT) of the TrustSec peer device in
hexadecimal.
Release Modification
12.2(33) SXI This command was introduced on the Catalyst 6500 series switches.