Cisco TrustSec - Page 143

7-57
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
debug condition cts
Condition 1: cts peer-id Zoombox (0 flags triggered)
Condition 2: cts security-group tag 7 (0 flags triggered)
Condition 3: cts security-group name engineering (0 flags triggered)
switch# debug cts ifc events
switch# debug cts authentication details
In the following example, SXP connection and mapping database messages are filtered by IP address and
SGT. Only SXP debug messages that contain IP address 10.10.10.1, or security-group tag = 8, or
security-group name = "engineering" are displayed.
switch# debug condition ip 10.10.10.1
Condition 1 set
switch# debug condition cts security-group tag 8
Condition 2 set
switch# debug condition cts security-group name engineering
Condition 3 set
switch# show debug condition
Condition 1: ip 10.10.10.1 (0 flags triggered)
Condition 2: cts security-group tag 8 (0 flags triggered)
Condition 3: cts security-group name engineering (0 flags triggered)
switch# debug cts sxp conn
switch# debug cts sxp mdb
Related Commands Command Description
show debug condition Displays all conditions set for debug commands.