7-58
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
default (cts manual interface configuration submode)
default (cts manual interface configuration submode)
To restore any of the cts manual configurations to their default values, use the default command in CTS
manual interface configuration submode.
default policy dynamic identity
default policy static sgt
default propagate sgt
default sap
Syntax Description
Command Modes CTS manual interface configuration submode (config-if-cts-manual)
Supported User Roles Administrator
Command History
Usage Guidelines To restore the CTS manual interface configuration submode parameters to default values, use the default
subcommand.
Examples The following example restores the default dynamic policy and SGT propagation policies of a Catalyst
6500 series switch CTS-enabled interface:
router# config t
router(config)# interface gigbitEthernet 6/1
router(config-if)# cts manual
router(config-if-cts-manual)# default policy dynamic identity
router(config-if-cts-manual)# default propagate sgt
dynamic identity Defaults to the peer policy downloaded from the AAA server.
policy static sgt Defaults to no policy. That is, no SGT is applied to ingress traffic.
policy propagate sgt Specifies SGT propagation mode of On.
sap Specifies default SAP values. (GCM-Encrypt, null)
Release Modification
12.2(50) SY This command was introduced on the Catalyst 6500 Series Switches.
To Next Page
Loading...
