Cisco TrustSec - Page 148

7-62
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
platform cts
platform cts
To enable the TrustSec egress or ingress reflector use the platform cts global config command. Use the
no form of the command to disable the reflector.
[no] platform cts {egress | ingress}
Syntax Description
Defaults The default is no ingress or egress reflector.
Command Modes Global configuration (config)
Supported User Roles Administrator
Command History
Examples The following example enables the CTS ingress reflector on a Catalyst 6500 switch:
switch(config)# platform cts egress
The following example disables the CTS ingress reflector on a Catalyst 6500 switch:
switch(config)# no platform cts egress
Related Commands
egress Specifies the egress TrustSec reflector to be enabled or disabled.
ingress Specifies the ingress TrustSec reflector to be enabled or disabled.
Release Modification
12.2(50) SY This command was introduced on the Catalyst 6500 Series Switches.
Command Description
show platform cts reflector Displays the status of the Cisco TrustSec reflector mode.