7-75
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
show cts
Defaults None
Command Modes EXEC (>); Privileged EXEC (#)
Supported User Roles Administrator
Command History
Examples The following is an example of show cts entered without keywords:
Router# show cts
Global Dot1x feature: Enabled
CTS device identity: "dcas1"
CTS caching support: disabled
Number of CTS interfaces in DOT1X mode: 19, MANUAL mode: 5
Number of CTS interfaces in LAYER3 TrustSec mode: 0
Number of CTS interfaces in corresponding IFC state
INIT state: 19
AUTHENTICATING state: 0
AUTHORIZING state: 0
SAP_NEGOTIATING state: 0
OPEN state: 5
HELD state: 0
DISCONNECTING state: 0
INVALID state: 0
CTS events statistics:
authentication success: 14
authentication reject : 19
authentication failure: 0
authentication logoff : 1
authentication no resp: 0
authorization success : 19
authorization failure : 3
sap success : 12
sap failure : 0
port auth failure : 0
server-list Displays the CTS server lists.
sxp Displays CTS SXP protocol information.
Release Modification
12.2(33) SXI This command was introduced on the Catalyst 6500 series switches.
12.2(50) SY The following keywords were added for Catalyst 6500 series switches:
To Next Page
Loading...
