Cisco TrustSec - Page 174

7-88
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
show cts policy layer3
show cts policy layer3
To display the name of traffic and exception polices used for CTS Layer3 Transport configurations, use
the show cts policy layer3 command in EXEC or privileged EXEC mode.
show cts policy layer3 {ipv4 | ipv6}
Syntax Description
Defaults None
Command Modes EXEC (>); Privileged EXEC (#)
Supported User Roles Administrator
Command History
Usage Guidelines A traffic or exception policy may be configured locally, or obtained from the Cisco Secure ACS.
See the section, “cts policy layer3” for additional information on the CTS Layer3 Transport feature.
Examples The following example displays the output of the show cts policy3 command:
router# show cts policy layer3 ipv4
No CTS L3 IPV4 policy received from ACS
Local CTS L3 IPv4 exception policy name : cts-exceptions-local
Local CTS L3 IPv4 traffic policy name : cts-traffic-local
Current CTS L3 IPv4 exception policy name: cts-exceptions-local
Current CTS L3 IPv4 traffic policy name : cts-traffic-local
Related Commands
ipv4 Specifies IPv4 policies.
ipv6 Specifies IPv6 policies
Release Modification
12.2(50) SY This command was introduced on the Catalyst 6500 series switches.
Command Description
cts policy layer3 Specifies traffic and exception policies for CTS Layer 3 Transport.
cts layer3 Enables and applies traffic and exception policies to CTS Layer 3 Transport
gateway interfaces.