Cisco TrustSec User Manual

7-2
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
CTS Interface Configuration Commands
cts dot1x Enters CTS dot1x Interface Configuration mode
(config-if-cts-dot1x).
cts layer3 Enables and applies traffic and exception policies
to CTS Layer 3 Transport gateway interfaces.
cts manual (config-if) Supply local configuration for CTS
parameters
platform cts Enables the TrustSec egress or ingress reflector.
CTS dot1x Submode Commands
default (cts dot1x interface configuration
submode)
Restores defaults for CTS dot1x commands.
propagate (cts dot1x submode) Enables/disables SGT propagation in dot1x mode.
sap (cts dot1x interface submode) Configures CTS SAP for dot1x mode.
timer (cts do1x interface submode) Configures the CTS timer.
CTS Manual Interface Configuration Submode Commands
default (cts manual interface configuration
submode)
Restores default configurations for CTS manual
mode.
policy (cts manual interface configuration
submode)
Configures CTS policy for manual mode
propagate (cts manual interface configuration
submode)
Configures CTS SGT Propagation configuration
for manual mode
sap (cts manual interface submode) Configures CTS SAP for manual mode.
Cisco TrustSec Clear Commands
clear cts cache Clears TrustSec cache file by type, by filename or
all cache files.
clear cts counter Clears the counters for a single TrustSec interface
or for all interfaces
clear cts credentials Clears all CTS credentials, including all PACs.
clear cts environment-data Clears TrustSec environment data from cache.
clear cts macsec Clears MACsec counters for a specified interface.
clear cts pac Clears a PAC or all PACs from the keystore.
clear cts role-based counters Displays role-based access control enforcement
statistics for SGTs and DGTs.
clear cts server Removes the specified authentication server.

Cisco TrustSec Specifications

General

Brand	Cisco
Model	TrustSec
Category	Switch
Language	English