7-3
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
Cisco TrustSec Show Commands
show cts authorization entries Displays the authorization entries.
show cts credentials Displays credentials used for CTS authentication.
show cts environment-data Displays the CTS environment data.
show cts interface Displays CTS states and statistics per interface.
show cts macsec Displays crypto ASIC packet counters per
interface.
show cts pacs Displays the A-ID and PAC-info for PACs in the
keystore.
show cts policy peer Displays the peer authorization policies of
TrustSec peers.
show cts policy layer3 Displays the traffic and exception policies used in
CTS Layer3 Transport.
show cts provisioning Displays outstanding CTS provisioning jobs
show cts role-based sgt-map Displays IP address to Security Group Tag
mappings.
show cts role-based counters Displays role-based access control enforcement
statistics for SGTs and DGTs.
show cts role-based sgt-map Displays IP to SGT bindings, permission lists, and
NetFlow statistics.
show cts server-list Displays lists of AAA servers and load balancing
configurations.
show cts sxp Displays CTS SXP protocol information.
show platform cts reflector Displays the status of CTS reflector per interface.
Commands to Configure Endpoint Admission Control (EAC)
aaa accounting
aaa authorization
aaa authentication
order
priority
event
periodic
timer
host-mode
authorization
accounting
radius-server host
authentication port-control
To Next Page
Loading...
Need help?
General