EasyManuals Logo

Cisco UC500 series User Manual

Cisco UC500 series
171 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
LAB 8B: UC520 Multi-site Setup
Cisco Unified Communications Technical Training
Page 141 of 171
17. To configure the dialplan, add the below CLI on the EVEN POD ONLY
voice translation-rule 82
rule 1 /^82\(…\)$/ /\1/
!
voice translation-profile evenpod
translate called 82
!
dial-peer voice 81000 voip
destination-pattern 81...
session protocol sipv2
dtmf-relay rtp-nte
codec g711ulaw
no vad
session target ipv4:1.1.100.xx
!where xx is the WAN IP address of the ODD POD
!
dial-peer voice 82000 voip
incoming called-number 82…
session protocol sipv2
dtmf-relay rtp-nte
codec g711ulaw
no vad
translation-profile incoming evenpod

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UC500 series and is the answer not in the manual?

Cisco UC500 series Specifications

General IconGeneral
BrandCisco
ModelUC500 series
CategoryVoIP
LanguageEnglish