Cisco UCS B200 M4 - Page 21

Step 2 Install the custom standoff in the same location at the back end of the motherboard.
Step 3 Position the GPU over the connector on the motherboard and align all captive screws to the standoff posts
(callout 1).
Step 4 Tighten the captive screws (callout 2).
Figure 18: Installing the NVIDIA M6 GPU
The following figure shows an NVIDIA M6 GPU installed in a Cisco UCS B200 M4 blade server.
Servicing a Blade Server
21
Servicing a Blade Server
Installing the NVIDIA M6 GPU Adapter Card