Cisco UCS C240 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)
26
CONFIGURING the SERVER
Supercapacitor Option
UCS-RAID-CV-SC= LSI CacheVault Power Module. This is a spare supercapacitor. It is the exact
same supercapacitor that ships with the 9271CV-8i, 9285CV-8e, and 9286CV-8e
cards listed earlier in this table and can be used as a replacement or upgrade
part.
RAID Configuration Options (not available for embedded RAID)
R2XX-SRAID0 Enable Single Disk Raid 0 Setting (for the following PIDs only):
■ UCS-RAID9271-8i or UCS-RAID9271CV-8I
■ UCSC-RAID-11-C240
■ UCSC-RAID-MZ-240
R2XX-RAID0 Factory preconfigured RAID striping option
Enable RAID 0 Setting. Requires a minimum of one hard drive.
R2XX-RAID1 Factory preconfigured RAID mirroring option
Enable RAID 1 Setting. Requires exactly two drives with the same size, speed,
capacity.
R2XX-RAID5 Factory preconfigured RAID option
Enable RAID 5 Setting. Requires a minimum of three drives of the same size,
speed, capacity.
R2XX-RAID6 Factory preconfigured RAID option
Enable RAID 6 Setting. Requires a minimum of four drives of the same size,
speed, capacity.
R2XX-RAID10 Factory preconfigured RAID option
Enable RAID 10 Setting. Requires a even number of drives (minimum of four
drives) of the same size, speed, capacity.
1. The 9285CV-8e supports PCI Express Gen 2
9271-8i, 9271CV-8i, 9286CV-8e, and Cisco Nytro MegaRAID 200 GB support PCI Express Gen 3.
NOTE: The 9266CV-8i and 9285CV-8e RAID controllers will reach end-of-life (EOL) in
November, 2013. After then, they will no longer be available.
NOTE: Although RAID levels 50 and 60 are not orderable from the factory, they are
supported for selected controllers as shown in
Table 6 on page 23
Table 8 Available PCIe RAID Controller Options (continued)
Product ID (PID) PID Description
To Next Page
Loading...
