Cisco UCS C240 M3 Specifications

Cisco UCS C240 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)
SUPPLEMENTAL MATERIAL
77
Drive Blanking Panels
A drive blanking panel (N20-BBLKD=) must be installed if you remove a disk drive from a UCS server. These
panels are required to maintain system temperatures at safe operating levels, and to keep dust away from
system components.
Upgrading your Server from Intel Xeon E5-2600 to Intel Xeon E5-2600 v2 CPUs (or
downgrading from Intel Xeon E5-2600 v2 to Intel Xeon E5-2600 CPUs)
See the following link:
http://www.cisco.com/en/US/docs/unified_computing/ucs/hw/CPU/IVB/install/IVB-B.html
Adding an Additional CPU (with CPU heat sink)
All Cisco UCS two CPU socket-capable servers can be upgraded from having one to having two CPUs
configured. You will need to order and install a heat sink when adding any additional CPU to a server.
Instructions for installing the new CPU and heat sink can be found at the following link:
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/replace.html#wp1233864
Motherboard Lithium Battery
You can order a replacement motherboard battery. Installation instructions are found at this link:
UCS-CPU-EP2-PNP=
Pick n place CPU tools for M3/EP v2 12 core CPUs (Purple)
9
UCS-CPU-GREASE2=
Thermal grease-for 2 CPUs-only for C220/C240-Red tip syringe
8
UCSX-HSCK=
UCS Processor Heat Sink Cleaning Kit (when replacing a CPU)
8
Notes . . .
1. This part is included/configured with your UCS server (in some cases, as determined by the configuration of
your server).
2. If your server contains an LSI MegaRAID SAS 9266-8i RAID controller card with battery backup
(UCS-RAID-9266), the card contains a battery backup unit (UCS-RAID-BBU), which can be replaced. If your
server contains an LSI MegaRAID SAS 9266-8i RAID controller card without a battery backup unit
(UCS-RAID-9266NB), the card does not contain a battery backup unit (UCS-RAID-BBU); however, you can
retrofit the card with a battery backup if desired. Note that you cannot retrofit a UCS-RAID-9266NB or
UCS-RAID-9266 RAID card with an LSI Cachevault Power Module (also known as a Supercap).
3. You can order a replacement only for the RAID cards listed. You cannot retrofit a UCS-RAID-9266NB or
UCS-RAID-9266 RAID card with an LSI Cachevault Power Module (also known as a Supercap)
4. The server is shipped with the inner rail attached to the chassis.
5. This SD card is preloaded with an image specific to the C240 server.
6. This SD card is blank. The required image for the C240 server can be downloaded to the card.
7. This part is included/configured with the server chassis.
8. This part is included with the purchase of each optional or spare Intel Xeon E5-2600 CPU processor kit.
9. This part is included with the purchase of each optional or spare Intel Xeon E5-2600 v2 CPU processor kit.
Table 39 Upgrade and Servicing-related Parts for UCS C240 M3 SFF Server
Spare Product ID (PID) Description

Cisco UCS C240 M3 Specifications

General

Processor cores	8
Processor model	E5-2600
Processor frequency	2.7 GHz
Number of processors installed	2
HDD size	2.5 \
RAID support	Yes
HDD interface	-
Optical drive type	No
Total storage capacity	300 GB
Maximum storage capacity	- TB
Number of HDDs installed	16
Memory slots	24
Internal memory	96 GB
Memory clock speed	1866 MHz
Internal memory type	DDR3-SDRAM
Maximum internal memory	- GB
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
PCI Express x8 slots	3
Chassis type	Rack (2U)
Power supply	650 W
Operating altitude	0 - 3000 m
Non-operating altitude	0 - 12000 m
Operating temperature (T-T)	-40 - 70 °C
Storage relative humidity (H-H)	5 - 93 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	712 mm
Width	445 mm
Height	87 mm