Cisco Unified IP Phone 8941 - Page 159

Possible explanation and actionDescriptionMessage
Check the load ID assigned to the phone (from
Cisco Unified Communications Manager, choose
Device > Phone). Verify that the TFTPPath
directory contains a .bin file with this load ID as
the name.
The requested load file (.bin)
was not found in the TFTPPath
directory.
TFTP file not found
Contact the Cisco TAC.The phone does not recognize
an error code provided by the
TFTP server.
TFTP error
•
The DHCP server has the wrong
configuration file for the TFTP server. In this
case, update the TFTP server configuration
to specify the correct TFTP server. The CTL
file was made and then the TFTP server
address changed. In this case, regenerate the
CTL file.
•
If the phone is using a static IP address, the
phone may be configured with the wrong
TFTP server address. In this case, enter the
correct TFTP server address in the Network
Setup menu on the phone.
•
If the TFTP server address is correct, there
may be a problem with the CTL file. In this
case, run the CTL client and update the CTL
file, making sure that the proper TFTP
servers are included in this file.
The specified TFTP server
could not be found in the phone
CTL file.
TFTP server not
authorized
•
Network is busy: The errors should resolve
themselves when the network load reduces.
•
No network connectivity between the TFTP
server and the phone: Verify the network
connections.
•
TFTP server is down: Check configuration
of TFTP server.
TFTP server did not respond.TFTP timeout
Authentication typically times out if 802.1X is not
configured on the switch.
Supplicant attempted 802.1X
transaction but timed out to due
the absence of an authenticator.
Timed Out
Make sure that the phone load file has the correct
name.
The name of the phone load file
is incorrect.
Version error
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
and SIP)
145
Cisco Unified IP Phone Status