Cisco Unified IP Phone 8941 - Set up Cisco Unified Communications Manager Features

NotesSupportedFeature
The softkey causes no action.NoPickUp
The softkey causes no action.NoGroup PickUp
The softkey causes no action.NoOther PickUp
The softkey causes no action.NoMalicious Call ID
The softkey causes no action.NoQRT
The softkey causes no action.NoHunt Group
The softkey causes no action.NoIntercom
The softkey causes no action.NoMobility
The softkey causes no action.NoPrivacy
The Call Back softkey does not
display.
NoCall Back
YesVideo
YesShared Line
Set Up Cisco Unified Communications Manager Features
Cisco Unified Communications Manager Administration allows you to set some product-specific configuration
parameters for Cisco IP Phones.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose one of the following windows:
•
Device > Phone (Phone Configuration window) Product Specific Configuration portion of window
•
Device > Device Settings > Common Phone Profile (Common Phone Profile Configuration window)
•
System > Enterprise Phone Configuration (Enterprise Phone Configuration window)
Step 2
Click the ? button in Cisco Unified Communications Manager Administration for descriptions of the parameters.
Step 3
When you set the parameters, check the Override Common Settings check box for each setting that you
wish to update.
If you do not check this box, the corresponding parameter setting does not take effect.
If you set the parameters in the three configuration windows, the setting takes precedence in the following
order:
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
54
Set Up Cisco Unified Communications Manager Features