DescriptionItem
Indicates whether DHCP is being used by the phone.DHCP
Enabled
Indicates the setting of the DHCP Address Released option on the phone Network Setup
menu.
DHCP
Address
Released
Indicates whether the phone is using an alternative TFTP server.Alternate
TFTP
URL that the phone displays when the phone has not been used for the time specified by
Idle URL Time, and no menu is open.
Idle URL
Number of seconds that the phone has not been used and no menu is open before the XML
service specified by Idle URL is activated.
Idle URL Time
URL of proxy server, which makes HTTP requests to nonlocal host addresses on behalf of
the phone HTTP client and provides responses from the nonlocal host to the phone HTTP
client.
Proxy Server
URL
URL that the phone uses to validate requests made to the phone web server.Authentication
URL
Indicates if the phone is enabled to synchronize the PC and SW ports to the same speed
and to duplex mode.
Automatic Port
Synchronization
Indicates if remote port configuration of the speed and duplex mode for the switch port is
enabled or disabled.
SW Port
Configuration
Indicates if remote port configuration of the speed and duplex mode for the PC port is
enabled or disabled.
PC Port
Configuration
Speed and duplex of the switch port, where:
•
A: Auto Negotiate
•
10H: 10-BaseT/half duplex
•
10F: 10-BaseT/full duplex
•
100H: 100-BaseT/half duplex
•
100F: 100-BaseT/full duplex
•
1000F:1000-BaseT/full duplex
•
No Link: No connection to the switch port
SW Port Setup
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
154
Cisco IP Phone Web Page
To Next Page
Loading...
