To changeDescriptionOption
Display only—Cannot configure.
The phone obtains its Operational
VLAN ID using Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use the
Admin VLAN ID option.
Auxiliary Virtual Local Area Network
(VLAN) configured on a Cisco Catalyst
switch in which the phone is a member.
If the phone has not received an auxiliary
VLAN, this option indicates the
Administrative VLAN.
If neither the auxiliary VLAN nor the
Administrative VLAN are configured, this
option defaults to a VLAN ID of 4095.
Operational VLAN ID
Set Admin VLAN ID Field, on page
36
Auxiliary VLAN in which the phone is a
member.
Used only if the phone does not receive an
auxiliary VLAN from the switch; otherwise
it is ignored.
Admin. VLAN ID
Set PC VLAN Field, on page 37Allows the phone to interoperate with
third-party switches that do not support a
voice VLAN. The Admin VLAN ID option
must be set before you can change this
option.
PC VLAN
Set SW Port Setup Field, on page
37
Speed and duplex of the network port. Valid
values are:
•
Auto Negotiate
•
1000 Full: 1000-BaseT/full duplex
(Supported only for Cisco Unified IP
Phone 8945.)
•
100 Half: 100-BaseT/half duplex
•
100 Full: 100-BaseT/full duplex
•
10 Half: 10-BaseT/half duplex
•
10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure
both to autonegotiate.
If you change the setting of this option, you
must change the PC Port Configuration
option to the same setting.
SW Port Setup
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
and SIP)
33
Configure Network Settings
To Next Page
Loading...
