Getting Started
Starting the Web-Based Configuration Utility
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 6
1
address can also be specified as the subnet IP address, so that all addresses in the
subnet are added to the local intranet zone.
• If you have multiple IPv6 interfaces on your management station, use the IPv6 global
address instead of the IPv6 local address to access the WAP device from your browser.
Launching the Web-Based Configuration Utility
To open the web-based AP configuration utility:
STEP 1 Open a web browser.
Enter the IP address of the WAP device that you are configuring in the address bar on the
browser and then press Enter. The Login page opens.Login
• To find your IP address, you can use the Cisco FindIT Network Discovery Utility. This
tool enables you to automatically discover all supported Cisco Small Business devices
in the same local network segment as your computer. For more information, go to
cisco.com and enter www.cisco.com/go/findit.
To Next Page
Loading...
Need help?
General
