To Next Page

To Previous Page

Appendix D

CGI Commands

Wireless-N Internet Home Monitoring Camera

Appendix D

If the client player is the QuickTime player, the latency is always approximately 3 second. If there is no audio

content in the streaming, you can use the extension parameter “[?|&]latency=no” to push the QuickTime

player to play the streaming video without any latency, but this method causes the frame rate to be unstable.

Example: rtsp://<ip>/img/video.sav?latency=no

Note that the camera is able to support the following four RTP protocols, but the user needs to specify the

desired RTP protocol in the player.

• Unicast RTP

• Multicast RTP

• RTP over RTSP (RTP over TCP)

• RTP over RTSP over HTTP (HTTP tunnel)

Return: Video and/or audio is returned.

Player Commands

Query

Method: GET

URL: http://<ip>/util/query.cgi[?extension=value]

This command retrieves the hardware capability, component setting or current status. For example, you can

query whether the camera has a speaker, I/O port, etc.

Parameter Value and description

extension

Extension value

yes: extension is enabled, the extended data as below will be extended to generic responses

fw_ver=V1.0.0 build 01\r\n

ip_addr=192.168.1.12\r\n

netmask=255.255.255.0\r\n

gateway=192.168.1.1\r\n

current_time=07/02/2008 10:12:10\r\n -> MM/DD/YYYY HH:MM:SS 24-Hour format

timezone=4\r\n

http_port=80\r\n

rtsp_port=554\r\n

Return:

HTTP/1.0 200 OK \r\n

…

content-type: text/plain\r\n

\r\n

<parameter pair>\r\n

......

Cisco WVC80N User Manual

Other manuals for Cisco WVC80N