CT-S310II Series Service Manual
- 16 -
Remove two “SCREW, NO. 0, THF (BT4-0.5) M2.0 4” that fasten “HOLDER, PAPER-03” and “SA, PE
SENSOR”. Pull the right and left frames at “FRAME, MAIN-03” outwardly and pull “HOLDER,
PAPER-03” upwardly until it is removed.
<Precaution at reassembly>
Align two bosses on the right and left sides of “HOLDER, PAPER-03” with holes at “FRAME, MAIN-03”.
Each slit must be aligned as well.
3. Disassembling “SA, MOTOR-03”
Remove “SCREW, BHT (ST), M3.0 6” and “SCREW, PHT (ST), M3.0 6” that fasten “FRAME,
MAIN-03” and “COVER, GEAR-03”.
<Precaution at disassembly / reassembly>
When reassembling, do not tighten the screws
excessively. Doing so may damage “COVER,
GEAR-03”. Be careful not to confuse two
different screw types.
SCREW, NO.0, THF (BT4-0.5) M2.0 4
Pull the right and left frames
outwardly while pulling it upwardly.
Hole for boss
Left frame
Slit
Hole for boss
Right frame
SCREW, PHT (ST), M3.0 6
SCREW, BHT (ST), M3.0 6
COVER, GEAR-03
To Next Page
Loading...
