CT-S310II Series Service Manual
5. SUPPLEMENT ARY INFORMATION
5-1. Self-printing
1) Function
This function is used to check the printer setting status by printing.
2) Starting self-printing
Turn the power on while holding down the FEED switch in the print possible status to print the
printer setting status on the roll paper. The printer prints out the following information and
cuts the paper.
(1) Printer type
(2) Firmware version
(3) Interface setting
(4) Buffer size
(5) DIP switch setting (only for the model equipped with serial interface)
(6) Memory switch setting
(7) Font A (20H to FFH)
(8) Font B (20H to FFH)
(9) Font C (20H to FFH)
(10) Kanji font A, 192 characters (only for the Kanji specification)
(11) Kanji font C, 192 characters (only for the Kanji specification)
(12) Line feeds are inserted until the cutting position is reached and the paper is cut.
3) Ending self-printing
When the preset print patterns have been printed, the printer will be reset and initialized.
- 53 -
To Next Page
Loading...
