CT-S310II Series Service Manual
5-2. Hex-dump Mode
This function is used to check whether the printer receives the data correctly when a problem, such
as a lack or duplication in the printed data, occurs. With this function, the received data can be
printed out in hexadecimal codes.
1) Starting the hex-dump mode
Check that the paper is set correctly and the cover is opened.
Turn the power on while holding down the FEED switch.
Close the cover.
After “HEX DUMP PRINT MODE” is printed on the roll paper, received data is printed out
in hexadecimal codes and their corresponding characters.
2) Ending the hex-dump mode
Press the FEED switch three times consecutively. “Completed” is printed out and paper
is fed to the paper cut position. Then the printer is reset.
Reset the printer by turning the power off or by the I/F signal.
Example of printing
HEX ダンプ印字モード
41 42 43 44 45 46 47 48 49 4A 4B 4C ABCDEFGHIJKL
42 43 44 45 46 47 48 49 4A 4B 4C 4D BCDEFGHIJKLM
43 44 45 46 47 48 49 4A 4B 4C 4D 4E CDEFGHIJKLMN
44 45 46 47 48 49 4A 4B 4C 4D 4E 4F DEFGHIJKLMNO
45 46 47 48 49 4A 4B 4C 4D 4E 4F 50 EFGHIJKLMNOP
46 47 48 49 4A 4B 4C 4D 4E 4F 50 51 FGHIJKLMNOPQ
47 48 49 4A 4B 4C 4D 4E 4F 50 51 52 GHIJKLMNOPQR
48 49 4A 4B 4C 4D 4E 4F 50 51 52 53 HIJKLMNOPQRS
Completed
HEX DUMP PRINT MODE
41 42 43 44 45 46 47 48 49 4A 4B 4C ABCDEFGHIJKL
42 43 44 45 46 47 48 49 4A 4B 4C 4D BCDEFGHIJKLM
43 44 45 46 47 48 49 4A 4B 4C 4D 4E CDEFGHIJKLMN
44 45 46 47 48 49 4A 4B 4C 4D 4E 4F DEFGHIJKLMNO
45 46 47 48 49 4A 4B 4C 4D 4E 4F 50 EFGHIJKLMNOP
46 47 48 49 4A 4B 4C 4D 4E 4F 50 51 FGHIJKLMNOPQ
47 48 49 4A 4B 4C 4D 4E 4F 50 51 52 GHIJKLMNOPQR
48 49 4A 4B 4C 4D 4E 4F 50 51 52 53 HIJKLMNOPQRS
Completed
Note
When there is no corresponding character, “. ” is printed.
All commands are disabled in the hex-dump mode.
When the data to be printed is less than one line, printing of that line is executed by pressing
the FEED switch.
- 55 -
To Next Page
Loading...
